MU-C Rear

Rear mounting

Manufactured from High Quality fine-grain QSt/E Steel with center mounted Cat. 1 3-point trestle for rear mounting
Belt rear mounting: Gearbox with integrated over run clutch for 540 r.p.m.

(1.000 r.p.m. possible as option, distance of the ground to PTO shaft cc. 50 cm) – up to 35 HP
Front mounting: low positioned gearbox with integrated over run clutch for 1.000 r.p.m.

(2.000 r.p.m. possible as option, distance of the ground to PTO shaft cc. 25 cm) – up to 35 HP
Belt protection with tension measuring slot
Shackle M Carbide fl ails to ensure long life, clean cut and maximum shredding using less power
Spiral Rotor with specially formed flail lugs to protect against damage from obstacles, bearings protected against dirt, wear

and tear
Patented removable shredding bar – System: "Shark fin"
Large support roller for adjusting height of mulcher
Additional Carbide wearing skids, removable
High tempered one way spring steel protection flaps in front of the mower hood
PTO shaft with hardened inner pipe and cap bottom lubrication

Mount for municipal quick-coupling triangle (installed on implement) for front mountintg
2 point Linkage parts for original mower deck linkages for Front Mowers instead of 3-point trestle Cat. I

(only for MU-C 100 and MU-C 120 available)
Support arms for Shibaura CM 214
MU-SOFA® weight transfer system, recommended for front-mounted machines
Wear insert in housing (factory mounted)
Second bolt on short chopping bar system with "shark fin" design – a Müthing patent (only for front mounting)
Strong, height adjustable support wheels, 360º swivel in front of the fl ail (Ø ca. 235 mm heigth and ca 80 mm wide) as

shown above