MU-C/S
Side Flail Mowers with fixed Offset Headstock
Working width 100 - 120 cm
For tractors up to 35 HP
Standard Equipment
- Manufactured from High Quality fine-grain QSt/E Steel with headstock Cat. 1 for rear mounting
- Fixed off set mounting for working near to the tractor, housing can be swivelled vertically
- Working range off set mounting to the right 58 cm (see chart)
- Working angle 90° up to 45° down
- Gearbox with integrated over run clutch for 540 r.p.m.
- Belt protection with tension measuring slot
- Hydraulic transport safety lock at an angle of 90° with shut-off tap
- Shackle M Carbide flails to ensure long life, clean cut and maximum shredding using less power
- Spiral Rotor with specially formed flail lugs to protect against damage from obstacles, bearings protected against dirt, wear and tear
- Patented removable shredding bar – System: "Shark fin"
- Support roller for adjusting height of mulcher.
- Side, wearing skids
- High tempered one way spring steel protection flaps in front of the mower hood
- Support leg
- 1 double acting spool valve required with float position
- PTO shaft with hardened inner tube and cap bottom lubrication
Options
- Modification from one double acting hydraulic valve to one single acting hydraulic valve for vertical movement
- Special Carbide wearing skids, removable
Working Ranges MU-C/S
- The stated measurements are approximate and may vary according to different Tractors
Technical Data
Model
|
WW | max tractor 540 r.p.m. |
Weight | No. Of flails |
MU-C/S 100 | 100 cm | 35 HP | 208 kg | 16 |
MU-C/S 120 | 120 cm | 35 HP | 225 kg | 20 |
