MU-E/S

Side Flail Mowers for Rear or Front mounting

Manufactured from High Quality fine-grain QSt/E Steel with headstock Cat. 1 + 2 for rear mounting
Hydraulic side shift (50 cm): Inner edge of mulcher from 86 cm to 136 cm outwards from centre of tractor
Working angle 90° up to 60° down
Gearbox with integrated over run clutch for 540 r.p.m. as an option 1.000 r.p.m.
Hydraulic transport safety lock at an angle of 90° with shut-off tap
Belt protection with tension measuring slot
Mechanical break back
Shackle M Carbide flails to ensure long life, clean cut and maximum shredding using less power
Spiral Rotor with specially formed flail lugs to protect against damage from obstacles, bearings protected against dirt, wear and tear
Patented removable shredding bar – System: "Shark fin"
Support roller for adjusting height of mulcher
Carbide wearing skids, removable
High tempered one way spring steel protection flaps in front of the mower hood
Support leg
2 double acting spool valves required, at least one with float position
PTO shaft with hardened inner tube and cap bottom lubrication

The stated measurements are approximate and may vary according to different Tractors

Please note: For Front mounting please state on a copy of the data sheet the driving direction of the Front P.T.O. (seen from behind to left or right

rotation) as well as the R.P.M., size and model of the P.T.O. itself.

When Front mounting please pay attention to the permitted Maximum Tractor Front Axle Load!