MU-H Hydro Vario

Front Flail Mower with Hydraulic Drive

Manufactured from High Quality fine-grain QSt/E Steel
Front mounting without Headstock
Hydraulic drive for a volume flow of 70 - 120 l/min, with integrated over run clutch
Hydraulic spool valves required:

1 x pressure flow

1 x pressure less return flow (max. counter-pressure <5 bar)

1 x oil leakage line to the hydraulic tank (max. counterpr. < 2 bar)
Belt protection with tension measuring slot
High tempered M Hammer flails to ensure clean cut and maximum shredding using less power
Spiral Rotor with specially formed flail lugs to protect against damage from obstacles, bearings protected against dirt, tear

and tear
Patented removable shredding bar – System: "Shark fin"
Support roller for adjusting height of mulcher
Side, wearing skids
High tempered spring steel one way protection flaps in front of the mower hood

Headstock Cat. 1 + 2 for front or rear mounting with mechanical side shift of 56 cm - as shown
Special 3-point linkage Cat. 1 (for special tractors like Reform, Aebi, Rasant etc.) up to 2.20 m working width, including additional

reinforcement rail parts
Hydraulic side shift (1 double acting spool valve required)
MU-SOFA® weight transfer system, recommended for front-mounted machines
Alternative flails and rotor systems (triple Y-blades, M-Shackle flails)
Adjustable Vario cutting bar for adjusting the shredding rate
Hood Wear plate (factory mounted)
Carbide wearing skids, removable
Second patented removable shredding bar – System: "Shark fin"
Warning signs with LED lighting equipment with turn signal failure indicator and lighting equipment support incl. 5 m cable

(fitted)
Operating hours counter with sensor