MU-H/S Vario

Rear and side multi-purpose Flail Mowers

Manufactured from High Quality fine-grain QSt/E Steel with headstock Cat. 2 for rear mounting
Hydraulic parallelogram side shift: 155 cm
Overall working range: up to 355 cm (see chart)
Working angle 90° up to 60° down
Gearbox with integrated over run clutch for 540 r.p.m.
Belt protection with tension measuring slot
Mechanical break back
Hydraulic transport safety lock at an angle of 90° with shut-off tap
High tempered M Hammer flails to ensure clean cut and maximum shredding using less power
Spiral Rotor with specially formed flail lugs to protect against damage from obstacles, bearings protected against dirt, wear and tear
Patented removable shredding bar – System: "Shark fin"
Support roller for adjusting height of mulcher
Side, wearing skids
High tempered one way spring steel protection flaps in front of the mower hood
Support leg
2 double acting spool valves required, at least one with float position
PTO shaft with hardened inner tube and cap bottom lubrication

Electro-hydraulic 6/2 distributor with handle and feeler (1 double acting spool valve with floating position required)
Alternative flails and rotor systems (triple Y-blades, M-Shackle flails)
Adjustable Vario cutting bar for adjusting the shredding rate
Wear insert in housing (factory mounted)
Additional Carbide wearing skids, removable
Second patented removable shredding bar – System: "Shark fin"
Warning signs with LED lighting equipment with turn signal failure indicator and lighting equipment support incl. 5 m cable (fitted)
Operating hours counter with sensor

The stated measurements are approximate and may vary according to different Tractors