Mthing Gmbeh & Co. KG - Soest, Landau, Neumarkt, Uffenheim, Bad Kreuznach, Langensteinach, Winterberg     

Deutsch English Franais Polski




Forgot Details?



Verge Mower for Rear mounting

Working Width 160 - 200 cm 

For Tractors up to 130 HP


Standard Equipment

  • Manufactured from High Quality fine-grain QSt/E Steel with headstock Cat. 2 for rear mounting
  • Working angle 90° up to 60° down
  • Gearbox with integrated over-run clutch for 1.000 r.p.m.
  • Hydraulic break back
  • Hydraulic control kit for separate height adjustment (2 single acting spool valves with float position required), adaptable for 1
    single acting spool valve)
  • High tempered M Hammer flails to ensure clean cut and maximum shredding using less power
  • Well balanced Spiral Rotor with specially formed flail lugs to protect against damage from obstacles and internal bearings
    protected against dirt, wear and tear
  • Patented removable shredding bar – System: "Shark fin"
  • Large support roller for adjusting working height of mulcher
  • Robust Starinth® rear roller bearing system (see page 12)
  • Swinging arm connection of headstock and mulching head together with optimized distance between the outer rotor circle
    and the roller guarantees perfect contour following and an even quality of cut
  • Side, wearing skids
  • High tempered spring steel one way protection flaps in front of the mower hood
  • Support leg
  • 1 single acting spool valve with float position required
  • PTO shaft with hardened inner tube and cap bottom lubrication


  • Hydraulic side shift (approx. 60 cm): 1 DA required (inner edge of mulcher from 110 cm to 170 cm outwards from centre of tractor)
  • Refitting to an output speed of 750 r.p.m. instead of 1.000 r.p.m. (additional)
  • Alternative flails and rotor systems (triple Y-blades, M-Shackle flails)
  • Hood Wear plate (factory mounted)
  • Second patented removable shredding bar – System: "Shark fin"
  • Carbide wearing skids, removable
  • Scraper bar for displaced support roller, incl. extended side panel for roller
  • Operating hours counter with sensor
  • Warning signs with LED lighting equipment with turn signal failure indicator and lighting equipment support incl. 5 m cable (fitted)


Working and Shifting Ranges MU-LV/S

  • The stated measurements are approximate and may vary according to different Tractors.

Technical Data

Max. Traktor
1.000 r.p.m.
No. of flails
MU-L/VS 160
160 cm
130 HP
950 kg
MU-L/VS 180
180 cm
130 HP
980 kg
MU-L/VS 200
200 cm
130 HP
1.010 kg