MU-M Vario

Front and Rear mounting

Manufactured from High Quality fine-grain QSt/E Steel with heavy duty multi position headstock Cat. 2 for front and rear mounting
Hydraulic side shift: 56 cm lifting range (1 double acting spool valve required)
Heavy duty gearbox with integrated over run clutch and through drive for 1.000 r.p.m.
Automatic belt tensioning
High tempered M Hammer flails to ensure clean cut and maximum shredding using less power
Spiral Rotor with specially formed flail lugs to protect against damage from obstacles, bearings protected against dirt, wear and tear
Patented removable shredding bar – System: "Shark fin"
Large, patented swivelling support roller for the option of discharging the mulch either behind or in front of the roller and for adjusting the working height of the mulcher
Robust Starinth® rear roller bearing system (see page 12)
Side, wearing skids
Carbide wearing skids, removable
High tempered one way spring steel protection flaps in front of the mower hood
Support leg
Slotted holes in the lower link points for perfect contour following and an even quality cut
PTO shaft with hardened inner tube and cap bottom lubrication

Front shock-absorbing spring assembly recommended
Alternatively we recommend the MU-SOFA® weight transfer system
Heavy duty PTO shaft with hardened inner tube and cap bottom lubrication
Refi tting to an output speed of 750 r.p.m. instead of 1.000 r.p.m. (additional)
Alternative flails and rotor systems: triple Y-blades, M-Shackle flails (not available for MU-M 300 Vario)
Adjustable Vario cutting bar for adjusting the shredding rate
Wear insert in housing (factory mounted)
Second patented removable shredding bar – System: "Shark fin"
Cleaner cutting edge for displaced support roller
Height adjustable support wheels, fixed axle with track 1.85 m, mounted at the 3-Point linkage
Warning signs with LED lighting equipment with turn signal failure indicator for front and rear mounting incl. 5 m cable
Operating hours counter with sensor