MU-PRO/S Vario

Rear and side multi-purpose Flail Mowers

Manufactured from High Quality fine-grain QSt/E Steel with headstock Cat. 3 for rear mounting
Hydraulic parallelogram side shift: 296 cm
Overall working range: up to 546 cm (see chart)
Working angle 90° up to 60° down
Heavy duty gearbox with integrated over run clutch for 1.000 r.p.m.
Automatic belt tensioning
Belt protection with tension measuring slot
Wear insert in housing (factory mounted)
Hydraulic break back
Hydraulic transport safety lock at an angle of 90° with shut-off tap
High tempered M Hammer flails to ensure clean cut and maximum shredding using less power
Spiral Rotor with specially formed flail lugs to protect against damage from obstacles, bearings protected against dirt, wear and tear
Patented removable shredding bar – System: "Shark fin"
Large, patented support roller for adjusting working height of mulcher, swivelling
Robust Starinth® rear roller bearing system (see page 12)
Carbide wearing skids, removable
High tempered one way spring steel protection flaps in front of the mower hood
Support legs
2 double acting spool valves required, at least one with float position
Heavy duty PTO shaft with hardened inner tube and cap bottom lubrication

Alternative flails and rotor systems (triple Y-blades, M-Shackle flails)
Adjustable Vario cutting bar for adjusting the shredding rate
Second patented removable shredding bar – System: "Shark fin"
Scraper bar for displaced support roller
Additional protection device for extremely stony conditions
Warning signs with LED lighting equipment with turn signal failure indicator and lighting equipment support incl. 5 m cable

(fitted)
Operating hours counter with sensor

The stated measurements are approximate and may vary according to different Tractors

Model	WW	Max. Tractor	Weight	No. of Flails	Min. tractor weight
MU-PRO/S 250 Vario	250 cm	200 HP	1.900 kg	22	7.000 kg